材料期刊网

SOLUTION BEHAVIOUR OF VARIOUS ALLOYING ELEMENTS IN Ni_3Si

LI Yundong , ZHANG Tianxiang , ZHENG Zhi , ZHU Yaoxiao Institute of Metal Research , Academia Sinica , Shenyang , China Professor , Institute of Metal Research , Academia Sinica , Shenyang , China

金属学报(英文版)

The solid solubilities of 15 common alloying elements added to the Ll_2-type intermetallic compound Ni_3Si at 900°C have been estimated,and their substitution modes have been de- duced from the direction of solubility lobe of the compound.It is shown that the alloying behaviours in Ni_3Si are determined by both size and electronic factors,i.e.,the substitution mode is governed by electronic configuration and solubility by the both.An interaction parameter is presented to describe quantitatively the influence of electronic configuration on substitution mode and the solubility limit can be successfully explained together with atom radius.

关键词: alloying behaviour , null , null , null

3 0CrMnSi 2A钢飞机主梁疲劳断裂分析

马康民 , 宣建光 , 康进兴

材料工程 doi:10.3969/j.issn.1001-4381.2001.10.012

用扫描电镜观察了某型飞机机翼主梁的疲劳断口,用疲劳条带估算了裂纹扩展寿命,并用Zheng-Hirt公式估算出裂纹尖端应力强度因子范围,估算结果与实验测定值十分接近,从而为研究老龄飞机的使用寿命,进行了有益的探索.

关键词: 机翼主梁 , 30crMnSiNi2A , 疲劳裂纹扩展寿命

1998 COMPREHENSIVE TABLE OF CONTENTS

中国腐蚀与防护学报

N。1Atmospheric Corrosivlty for Steels………………………………………………… .LIANG Caideng HO[I i。-tat（6）Caustic Stress Corrosion Cr。king of Alloy 800 Part 2.The Effect of Thiosul执e……………………………………… KONG De-sheng YANG Wu ZHAO Guo-zheng HUANG De.ltL。ZHANG Yu。。he CHEN She。g-bac（13）SERS slid E16CttOCh6iniC81 Stlldy Of Illhibit1Oli M6ch＆tllsth Of ThlollY68 Oil ITOll ID H....

关键词:

Monte Carlo simulation of angular distribution and fractionation in the zero-fluence isotope sputtering

Nuclear Instruments & Methods in Physics Research Section B-Beam Interactions with Materials and Atoms

A static Monte Carlo simulation program has been used to study the influence of primary and secondary knock-on atoms on the angular distribution and the fractionation, for zero-fluence sputtering of Mo-92-Mo-100. At 10 keV Xe ion energy, calculations show that significant depth-dependent momentum asymmetry exists in the near-surface region, as in Refs. (L.P. Zheng, R.S. Li, M.Y.LI, Nucl. Instr, and Meth. B 100 (1995) 490; L.P. Zheng, M.Y. Li, Nucl. Instr. and Meth. B 114(1996) 28). The calculations also show that at the polar emission angle range between 0 degrees and 90 degrees the probabilities of the sputtered primary knock-on atoms for Mo-92 and Mo-100 are small (6.1% for Mo-92 and 6.6% for Mo-100), especially, between 0 degrees and 30 degrees they are very small (2.5% for Mo-92 and 2.8% for Mo-100). At 0.1 keV Ar ion energy, the calculations show that partial momentum flux ratios, for the primary and the secondary knock-on atoms, deviate far from one, through marker plane 1 (about an atomic layer distance from the surface). (C) 1998 Elsevier Science B.V. All rights reserved.

关键词: mo-92-mo-100;targets

LC4铝合金稀土转化膜耐蚀性及影响因素

张巍 , 李久青 , 许江涛 , 陈昆

腐蚀科学与防护技术 doi:10.3969/j.issn.1002-6495.1999.06.004

开发了IC4铝合金稀土转化膜碱性两步成膜工艺ZH1,利用正交优化设计方法确定了最佳工艺参数.采用多种实验方法研究了经ZH1处理的LC4铝合金在氯化物环境中的耐蚀性及其影响因素,结果表明:经ZHI工艺处理过的LC4铝合金耐全面腐蚀和点蚀性能均有明显提高,稀土转化膜既抑制了腐蚀的阴极过程,也抑制了阳极过程.具有ZH1转化膜的LC4铝合金对氯离子浓度和pH值的变化不甚敏感.

关键词: 高强铝合金 , 稀土转化膜 , 耐蚀性学科

Fe80Si9B11非晶合金薄带热膨胀特性和结构弛豫分析

李红 , 孙克 , 李艳萍 , 石毅 , 郭金花 , 卢志超

金属功能材料

提出了采用推杆式热膨胀仪测试非晶合金薄带热膨胀特性的新方法.分析了Fe80Si9B11非晶薄带的热膨胀曲特性和非晶合金晶化过程.根据R.G.Zheng理论分析了结构弛豫中自由体积比变化,发现自由体积比曲线出现双峰.结合晶化前发生相分离的理论分析了这种变化的原因.分析表明:铁基非晶Fe80Si9B11晶化过程中先形成α-Fe(Si)相,再析出Fe3B、二次α-Fe(Si)相.晶化前先发生相分离,自由体积比增大,然后析出结晶相α-Fe(Si),自由体积比降低.随温度升高,B偏聚,自由体积比增大,随后析出Fe3B、二次α-Fe(Si)相,自由体积比降低.

关键词: 铁基非晶薄带 , 热膨胀系数 , 自由体积比 , 结构弛豫